Wood-mizer LX55 - Clutch Lever Installation (Gas Versions Only)

Assembly
Clutch Lever Installation (Gas versions only)
Assembly LX55 9/17/20 3-25
3
3.11 Clutch Lever Installation (Gas versions only)
1. Attach the clutch lever assembly as shown in Fig. 3-34.
2. Attach the ring end of the clutch cable to the clutch lever.
3. Set the cable in the bracket; adjust as needed. See Fig. 3-35.
4. Route the cable through the sawhead grommets and attach it to the clutch. See Fig. 3-35.
5. See Section 4.8
for information on cable adjustment.
FIG. 3-34
FIG. 3-35
55001-26
Clutch Cable
Bolt, M6x20mm
Bolt, M8x75mm
550011
550014
Tighten nut
Clutch cable
Throttle cable
Clutch cable in
center position