Wood-mizer LX55 - Page 47

Assembly
Install the Blade
Assembly LX55 9/17/20 3-29
3
6. Place the new blade around the blade wheels and under the blade guide rollers. See FIG.3-39.
NOTE: When installing a blade, make sure the teeth are pointing t toward
the dust chute. If necessary, invert the blade as shown in the video.
7. Position 1 1/4” wide blades (standard) on the wheels so the gullet is 1/8" (3.0 mm) out from the
edge of the wheel. See Fig. 3-40.
Go directly to the Section 4, Alignment
to align it before use.
FIG. 3-39
FIG. 3-40
55001-38
150060
1/8” (3.0 mm)
± 1/32” (0.75 mm)
1 1/4”
Blade