Alignment
Tracking the Blade
Alignment LX55 9/17/20 4-2
4
5. Turn off the engine/motor and check the position of the blade on the blade wheels. See Fig. 4-2
6. Use the cant controls to adjust where the blade travels on the blade wheels.
NOTE: If the blade is too far out, back the blade onto the wheel by turning
the cant control counterclockwise. If the blade is too far in, turn the cant
control clockwise until the gullet of the blade is the correct distance from
the front edge of the wheel. See Fig. 4-2.
7. Repeat these steps until the blade tracks properly on the blade wheels.
FIG. 4-2
FIG. 4-3
150060
1/8” (3.0 mm)
± 1/32” (0.75 mm)
1 1/4”
Blade
To Next Page
Loading...
