Alignment
Blade Guide Vertical Tilt Alignment
4
4-7 LX55 9/17/20 Alignment
OUTER BLADE GUIDE
1. If using optional adjustable blade guide arm, open the blade guide arm 1/2" (13 mm) from
fully open.
2. Clip the alignment tool on the blade.
3. Position the tool close to the outer blade guide assembly.
NOTE: Ensure the tool does not rest on a tooth or burr, and is lying flat
against the bottom of the blade.
See Figure 4-9.
4. Move the carriage so that the front end of the tool is positioned above the bed rail.
5. Measure the distance from the bed rail to the bottom edge of the tool.
6. Move the carriage so that the back end of the tool is positioned above the bed rail.
7. Measure the distance from the bed rail to the bottom edge of the tool.
8. If the measurement from the tool to the bed rail is not equal within 1/32" (.75 mm), adjust the ver-
tical tilt of the outer blade guide roller.
9. Loosen one set screw at the side of the blade guide assembly.
FIG. 4-9
FIG. 4-9
SM0069B
Clip tool to blade
SM0310-1
Adjust screws down
to tilt roller up; Adjust
screws up to tilt roller
down
Bottom Vertical Tilt
Adjustment Screw
Top Vertical Tilt
Adjustment Screw
To Next Page
Loading...
