SPECIFICATIONS
Dust Extractor Specifications
Specifications EGdoc042320 7-6
7
7.3 Dust Extractor Specifications
See Table 7-10. Specifications of the dust extractors used on the for each saw head are listed below.
1
IMPORTANT! The dust extractor hoses must be grounded or made with
materials not accumulating electrostatic charge.
CAUTION! Always turn on the dust extractor before starting the machine
IMPORTANT! The total value of hand-arm vibration the operator may be
exposed to does not exceed 2.5 m/s2. The highest root mean square
value of weighted acceleration to which the whole operator’s body is
subjected does not exceed 0.5 m/s2.
Airflow
1200 m
3
/h
3937ft
3
/h
Inlet diameter 100 mm (5.9”)
Motor power 1,5 kW
Number of sacks 1 pcs
Sack capacity
0,25 m
3
(8.8 ft)
3
Weight 110 kg (242.5 lb)
Pressure drop
1,5 kPa (0.22 psi)
1
1
The pressure drop between the inlet of the capture device and
the connection to the CADES should be maximum 1,5 kPa (for
the nominal air flow rate). If the pressure drop exceeds 1,5 kPa
the machine might not be compatible with conventional
CADES.
Recommended conveying air
velocity in the duct
20 m/s
65.6 ft/s
TABLE 7-10
1. External chip and dust extraction equipment with fixed installations are dealt with in EN
12779:2016-04.
To Next Page
Loading...
