Wood-mizer MP100 Series - Page 37

MOULDER ASSEMBLY
Head Assembly
MOULDER ASSEMBLY 15doc042320 3-17
3
See Figure 3-11. MP100 Moulder Mounted on the LT10 Bed Frame.
3. Assemble the retaining bracket to the right side of the mast with two hex head bolts and flat washers.
4. Assemble the four track wipers to the left and right sides of the mast using the hex head bolt and flat
washers.
NOTE: Before installing the felt wipers, soak the felt strips with lubricating fluid.
5. Install the PC operator guard.
6. Assemble the mast safety pins.
FIG. 3-11
Track Wiper
M6 X 12 Hex
Head Bolt (2)
Retaining Bracket
6.4 Flat
Washer (4)
M8 X 16 Hex
Head Bolt
M6 Split Lock
Washer
M8 X 16
Hex
Head Bolt
M10 X 40 Hex
Head Bolt
M8 X 16 Hex
Head Bolt
M8 X 25 Hex
Head Bolt