Wood-mizer MP100 Series - Manual Feed Rope Assembly

MOULDER ASSEMBLY
Manual Feed Rope Assembly
MOULDER ASSEMBLY 15doc042320 3-19
3
3.6 Manual Feed Rope Assembly
1. Install a feed rope mounting bracket at each end of the bed assembly using a M12x55 hex head bolt and a
nylon lock nut. Either bracket should be angled toward the end of the frame at which it is mounted as shown
below.
See Figure 3-13.
2. Tie a knot in one end of the feed rope. Slip the knotted end of the rope into the front rope mount bracket.
Route the rope between the head and the main bed frame tube.
See Figure 3-14.
FIG. 3-13
FIG. 3-14
150110e
M12x55 Bolt
Front Rope
Mount
Bracket
092569-1
13 Washer
M12 Nut
Rear Rope
Mount Bracket
092569-1
M12x55 Bolt
15B007