SETUP & OPERATION
Moulder Setup
4
4-5 EGdoc042320 Operation
See Figure 4-2.
7. If the dimensions A and B are not the same, adjust the head tilt as shown in the Figure 4-3.
See Figure 4-3. To adjust the head tilt, loosen the four mounting bolts of the side roller bracket, the
two wiper mounting bolts and the two mounting bolts of the mast retaining bracket. Use the head
adjustment nuts to move the outside of the head up or down.
FIG. 4-2
FIG. 4-3
Roller Bracket
Mounting Bolt (4)
Head
Adjustment Nuts (2)
Lock Nut
Mast Retaining
Bracket Mounting
Bolts (2)
Wiper Mounting
Bolts (2)
To Next Page
Loading...
