Wood-mizer MP100 Series - Log Clamp Operation

SETUP & OPERATION
Log Clamp Operation
4
4-7 EGdoc042320 Operation
4.2 Log Clamp Operation
To Clamp Logs
1. Position the clamps against the log, far enough down, below level of working knives. Turn the clamp
screws in so they move the log firmly against the side supports.
See Figure 4-4.
2. Be sure to leave crank in the bottom position to avoid damage.
See Figure 4-5.
FIG. 4-4
FIG. 4-5
sm0380_A
sm0379_A