SETUP & OPERATION
Moulder Operation, MP100
Operation EGdoc042320 4-16
4
4.4 Moulder Operation, MP100
4.4.1 Control Overview
See Figure 4-17. The controls of the MP100 moulder are shown below:
1. Key Switch
1
The key switch has three positions:
“0” position - all electrical circuits are off,
position - all electrical circuits are on,
position - releases the motor brake.
2. Safety Handle
1
Stops the cutter motor when released.
3. Motor START Button
FIG. 4-17
1 It does not concern the US version.
Safety Handle
1
Cutter Height
Scale
Main Power
Switch
Emergency Stop
Button
Power ON Control
Light
Key Switch
1
Motor START
Button
Cutter Height
Blocking Clamp
Up/Down and
Feed Crank
To Next Page
Loading...
