SETUP & OPERATION
Feed Operation
Operation EGdoc042320 4-24
4
4.5.23 Feed Operation
1. Set the key in position.
2. Push the power feed switch to move the head forward or pull the switch to move the head backward.
See Figure 4-23.
3. It is possible to adjust the cutter right or left. The maximum adjustment available is 110mm (4.33”).
To slide the cutter, first loosen the locking knobs (4). Use the cutter scale to measure the distance
from the initial position. (When the cutter is in the extreme left position, the cutter scale shows 0.)
IMPORTANT! Always make sure that all locking knobs are firmly tightened before using the moulder.
FIG. 4-23
To Next Page
Loading...
