SETUP & OPERATION
Machine Start-Up (MP100)
Operation EGdoc042320 4-26
4
4.6 Machine Start-Up (MP100)
DANGER! Before starting the machine, perform the following steps to
avoid injury and/or damage to the equipment:
Close or mount any covers removed for service.
Check that the wood to be planed/moulded is properly secured.
Make sure that all persons are at a safe distance from the machine.
Turn on the dust extraction system.
Check if the emergency stop button is released.
NOTE: The machine will not start if the emergency stop is on.
To start moulding/planing:
1. Make sure that the head is secured at the desired height with the locking handle.
2. Turn the main switch on the electrical box to the ON position.
3. Press AND HOLD the safety handle. NOTE: If the safety handle is released, the cutter disengages
and stops.
1
4. Turn the key switch to position.
1
1 It does not concern the US version.
To Next Page
Loading...
