SETUP & OPERATION
Machine Start-Up (MP150)
Operation EGdoc042320 4-28
4
4.7 Machine Start-Up (MP150)
DANGER! Before starting the machine, perform the following steps to
avoid injury and/or damage to the equipment:
Close or mount any covers removed for service.
Check that the wood to be planed/moulded is properly secured.
Make sure that all persons are at a safe distance from the machine.
Turn on the dust extraction system.
Check if the emergency stop button is released.
NOTE: The machine will not start if the emergency stop is on.
To start moulding/planing:
1. Set the head height as desired using the up/down buttons.
2. Turn the main switch on the electrical box to the ON position.
3. Press AND HOLD the safety button.
NOTE: If the safety button is released, the cutter disengages and
stops.
4. Turn the key switch to position.
To Next Page
Loading...
