SETWORKS OPERATION
Memory Buttons (A, B, C, D, E)
5
5-5 EGdoc042320 SETWORKS OPERATION
Enter the measured distance without a pause. For example: if you want to enter 250mm - press
2-5-0-0 without a pause. Confirm by pressing .
5.3 Memory Buttons (A, B, C, D, E)
After switching-on, the “MPS-01” inscription appears on the display, and the Setworks is ready for
operation within a few seconds or after is pressed.
The Setworks is designed to automatically lower the cutter (by 1mm / 0.039” - 5 mm / 0.197”) below its
current position. IMPORTANT! Remember that the maximum planing thickness can be 4 mm.
To automatically lower the cutter, enter the required value (from 1mm / 0.039” - 5 mm / 0.197”)
using the keypad and press . The cutter will automatically be lowered by the entered value.
You can also change the cutter position using .
You can store up to five values using the memory buttons.
To store the value, press and hold . The inscription “ABC” will appear on the upper display.
Press the memory button (A, B, C, D or E), enter the value and confirm by pressing .
Perform the same procedure for other memory buttons.
To Next Page
Loading...
