Wood-mizer PD200 Series - Page 27

Maintenance
Changing the blade
Maintenance doc061821 4-3
4
2. Release the tension by ratcheting the device until the pivot arm is fully released.
See Figure 4-2.
3. Removed the used blade.
4. Install the new blade on the center of the drive wheel tires.
IMPORTANT! Ensure the blade is positioned as shown below in
Figure 4-3.
See Figure 4-3.
FIG. 4-2
FIG. 4-3
DM200-02
Tension ratchet
handle
DM200-09
From the blade guides,
the teeth hooks move
towards the motor.
Flat edge of the blade
rides along the rear
blade guide roller.