WoodFast M910 User Manual

INSTRUCTION MANUAL
NSW Schools / TAFE - M910
Long Bed Wood Lathe Variable Speed
(240V)
520 x 975mm
K8120
Page 1
Instruction Manual for M910 (K8120)
11/25/2015

WoodFast M910 Specifications

General

Brand	WoodFast
Model	M910
Category	Lathe
Language	English

Summary

Lifting of the Machine

Unpacking the Machine

Installation

Assembly of lathe stand

Bolting the lathe to the stand

Ensuring the lathe bed is securely and correctly levelled on the stand.

Connect motor and switch to power

Connecting the motor and switch to the power supply.

Electricals

Connect the motor and switch to the power

Details on connecting the motor and switch to the power supply.

Working with the lathe

Changing Speed Ranges

How to adjust spindle speeds for different turning tasks.

Woodturning

Maintenance

Replacing Drive Belt

Step-by-step guide to replacing the drive belt.

Fitting a new headstock pulley

Procedure for fitting a new headstock pulley.

Removing main spindle

Removing old bearings

Replacing new inboard bearings

Guidance on replacing inboard bearings correctly.

Replacing main spindle

Procedure for re-fitting the main spindle.

Replacing new outboard bearings

Instructions for installing new outboard bearings.

Tailstock spindle and handwheel service

Stand Assembly

Ensure the motor bracket is securely locked.

Roll the main channel over onto woodlathe mounting surface.

Place the legs onto the main channel and attach using:

Roll the main channel with the legs attached to upright position.

Place the woodlathe onto the main channels and attach using:

Mounting the wood lathe onto the main channels.

When supplying your own motor ensure both pulleys are aligned before fixing to the motor plate using screws provided.

Move the machine/stand in the position to be secured to the floor.

Positioning the machine and stand for floor securing.

Use the 4 off M8 x 25 Set screws in the threaded holes to stabilise the machine and lock the screws with the 4 off M8 standard nuts before fixing to the floor.

Stabilizing and locking the machine using set screws and nuts.

TO SECURE SWITCH GEAR TO SWITCH PLATE:

Secure the remote switch to the switch plate using:

Inside the door of the main channel section of the stand, connect the terminal plug for safety switch.

Accident Prevention and Tips

General Operation Safety

Essential safety precautions for operating the wood lathe and personal protection.

Workpiece and Tool Handling Safety

Guidelines for safe workpiece support, tool usage, and setup procedures.

Trouble Shooting

Electronic Speed Control Unit

General Usage and Danger Warnings

Instructions and warnings for operating the electronic speed control unit.

Adjusting Speed Control Settings