To Next Page
M
Melody Henry DDSAug 3, 2025
Why is my Woodland Mills WC46 Chipper brush feeding too slowly?
- Rrenee02Aug 3, 2025
If the brush is feeding too slowly on your Woodland Mills Chipper, there are several potential causes: * The infeed roller control might be set too low. Increase the infeed roller control to a higher value. * The PTO RPM might be below 540. Adjust the tractor RPMs to 540 at output. * The blades could be dull. Reverse, sharpen, or replace the blades. * The bed plate gap might be improper. Re-set the bed plate gap.
General
