Step 10: Disassembly Step 11: Packing the tentStep 8: Secure guy lines
1) Secure tent using all guy lines and stakes.
Tent must be secured for proper function.
1) To take down the tent, disassemble in
reverse order.
2) Remove accessories (if included).
3) Remove and fold fly.
4) Be sure to leave doors and windows
unzipped to avoid zipper damage.
5) Remove stakes with hammers or stake
puller. DO NOT pull on tent.
6) Carefully disengage poles from fast feet.
Carefully push pole away from you through
the hanger to minimize risk of damage to
tent or poles.
7) Keep stakes in bags provided.
1) Spread tent flat, distribute evenly.
2) Fold into quarters not to exceed the length
of pole bag.
3) Lay pole bag at opposite end from door.
Tightly roll bag, skin and fly forcing air
through unzipped door.
4) Secure with ties and place in carry bag with
stakes and accessories.
5) Tent must be clean and dry before storage.
Store off concrete floor.
Be certain campfires are extinguished.
Dispose of trash appropriately.
Dimension A should
be close to but not
exceed the length
of the pole bag.
A
Fold tent into a
rectangular shape.
Front of tent
(door unzipped)
Step 5: Stake tent
1) Stake down the tent by inserting a stake
through the stake loops, located along the
perimeter of the tent.
2) Make certain the tent floor is pulled out
evenly and tightly.
3) Hammer the stakes into the ground at a
45˚ angle using a hammer or mallet.
Step 9: Fully assembled
Tent appears as shown.
Note: Interior accessories if included with this
model can be attached to the loops inside the
tent.
Step 6: Attach fly
1) Unfold the fly and place over the tent.
2) Wrap the Velcro® fasteners sewn on the
underside of the fly to the roof poles.
3) Attach the fly to the tent by hooking the
plastic s-hook on the fly corners to the
plastic d-ring connected to the fast feet.
4)
Wrap the
Velcro®
fasteners sewn on the
underside of the fly around the leg poles.
Step 7: Secure fly pole and fasten the fly
1) Insert the fly pole (F) through the sleeve at the edge of the fly found over the front door.
2) Place pole ends into the fast feet at the outer corners of the tent front.
3) Attach fly to the d-ring at front tent corners.
4)
Zip the front panel shut. Position and stake into place at the front fly corners. Fly front panel can be
rolled up and fastened at the fly pole.
5)
Vents at the sides and back may be staked in place.
To Next Page
Loading...
