Step 11: Disassembly Step 12: Packing the tent
Step 8: Secure guy lines
1) Secure tent using all guy lines and stakes..
Tent must be secured for proper
function.
1) To take down the tent, disassemble in
reverse order.
2) Remove accessories (if included).
3) Remove and fold fly.
4) Be sure to leave doors and windows
unzipped to avoid zipper damage.
5) Remove stakes with hammer or stake
puller. DO NOT pull on tent.
6) Carefully disengage poles from fast feet.
Carefully push pole away from you through
the hanger to minimize risk of damage to
tent or poles.
7) Keep stakes in bags provided.
1) Spread tent flat, distribute evenly.
2) Fold into quarters not to exceed the length
of pole bag.
3) Lay pole bag at opposite end from door.
Tightly roll bag, skin and fly forcing air
through unzipped door.
4) Secure with ties and place in carry bag with
stakes and accessories.
5) Tent must be clean and dry before storage.
Store off concrete floor.
Be certain campfires are extinguished.
Dispose of trash appropriately.
Dimension A should
be close to but not
exceed the length
of the pole bag.
A
Fold tent into a
rectangular shape.
Front of tent
(door unzipped)
Step 5: Stake tent
1) Stake down the tent by inserting a stake
through the stake loops, located along the
perimeter of the tent.
2) Make certain the tent floor is pulled out
evenly and tightly.
3) Hammer the stakes into the ground at a
45˚ angle using a hammer or mallet.
Step 10: Fully assembled
Tent appears as shown.
1) Unfold the fly and place over the tent. Position the
logo on the left side of the tent.
2) Attach hook and loop tabs on the underside of the fly to
the frame.
3) Attach the fly to the tent by attaching the plastic buckle
on fly ends to corresponding buckle located at the stake
loops. Buckles can be adjusted to make fly taut.
Step 6: Attach fly
Step 7: Insert and secure fly pole
1) Insert the fly pole (F) through the
sleeve found at the edge of the
fly over the front door.
2) Flex the pole and insert each end
into the plastic hub attached to the
front leg poles (D).
Step 9: Attach mud mat
1) Attach the rings on the mud mat to the
toggles near the bottom of the door.
2) Insert stakes in loops at outer corners
of the mud mat. Hammer the stakes
into the ground at a 45
0
angle using a
hammer or mallet.
1) Accessories may be attached.
CTC161410-2 10/15
To Next Page
Loading...
