4 Introduction
MAN1248 (2/26/2018)
SPECIFICATIONS
GENERAL INFORMATION
Some illustrations in this manual show the cut-
ter with safety shields removed to provide a better
view. The cutter should never be operated with any
safety shielding removed.
The purpose of this manual is to assist you in operating
and maintaining your cutter. Read it carefully. It fur-
nishes information and instructions that will help you
achieve years of dependable performance. These
instructions have been compiled from extensive field
experience and engineering data. Some information
may be general in nature due to unknown and varying
operating conditions. However, through experience
and these instructions, you should be able to develop
procedures suitable to your particular situation.
The illustrations and data used in this manual were cur-
rent at the time of printing, but due to possible inline
production changes, your machine may vary slightly in
detail. We reserve the right to redesign and change the
machines as may be necessary without notification.
Throughout this manual, references are made to right
and left directions. These are determined by standing
behind the equipment facing the direction of forward
travel. Blade rotation is counterclockwise as viewed
from the top of the cutter.
DBH5.31
DBH5.31Q DBH6.31 DBH6.31Q
Cutting Width 60" 60" 72" 72"
PTO Speed (rpm) 540 1000 540 1000
Blade Tip Speed (feet per minute) 15,800 16,000 18,900 17,700
Minimum Tractor Weight Recommended 4000 lbs 4000 lbs 5000 lbs 5000 lbs
Minimum Tractor HP Recommended 55 HP 55 HP 60 HP 60 HP
Minimum 3-Point Lift Capacity 2500 lbs 2500 lbs 3000 lbs 3000 lbs
Weight (Approximate)
Including Hydraulic Oil and Counter Weights
2250 lbs. 2450 lbs.
Cutting Height (Depending on 3-point hitch height) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2" - 10"
3-Point Hitch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Category 2 & 3
Offset from Centerline Tractor PTO to Inside Edge of Cut (Approximate). . . . . . . . . . . . . . . . . . . . . . . . . . . 65"
Transport Width from Centerline PTO to Right Side with Head Raised (Approximate). . . . . . . . . . . . . . . . . 73"
Transport Width from Centerline PTO to Left Side with Head Raised (Approximate) . . . . . . . . . . . . . . . . . . 51"
Blade Rotation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . CCW
(With Option to Convert To CW)
To Next Page
Loading...
