Step 4: Raise the screen house
1) Extend all roof poles until they lock into open position.
2) Extend all leg poles upward until they lock into open position.This action raises the screen house.
3) Make sure all clips are secured to poles.
1)
Pull the screen house out even and tight, with all doors closed, allowing sod cloth to lay flat
on the ground.
2)
Stake down by inserting stakes through all stake loops around perimeter of screen house.
3)
Hammer stakes into the ground at
45
0
angle using a hammer or mallet.
4)
Secure all guy lines. Tent must be secured for proper function.
Step 5: Fully assembled
Button locks click
when poles are extended
to correct position
Make sure all clips
are secured to poles
Hub in open
position
Secure stakes at
45 degree angle
Be certain campfires are extinguished. Dispose of trash appropriately.
Step 6: Disassembly and packing the tent
1) Be sure to leave the doors and windows unzipped to avoid zipper damage.
2) Remove stakes with hammers or stake puller. DO NOT pull on tent.
3) Take down the tent , disassemble in reverse order.
4) Depress the locking button and collapse each telescoped leg.
5) Fold legs inward from the corner joint.
6) Fold all the poles together above the centre hub.
7) Lay tent on its side. Roll until excess air is expelled.
8) Secure with ties and place in carry bag.
9) Keep loose poles and stakes in bags provided.
10) Tent must be clean and dry before storage. Store off concrete floor.
CTC 161111SH 9/15
To Next Page
Loading...
Need help?
General
