Woodward DSLC-2 - Table 3-22: Parameter - Configuration - System Management

Manual 37443A DSLC-2 - Digital Synchronizer and Load Control
Page 88/226 © Woodward
Factory Settings
ID
Parameter
CL
Setting range
Default
Description
10417
Factory
default
settings
0 No / Yes No Selecting “Yes” will allow the reset back to Factory default settings
by selecting “Yes” for the Reset factory default values parameter
(parameter 1701).
1701
Reset factory
default
values
0
No / Yes
No
No: All parameters will remain as currently configured.
Yes: All parameters, which the enabled access code grants privi-
leges to, will be restored to factory default values. This value re-
turns to “No” when factory defaults are set.
Table 3-22: Parameter – configuration – system management