Manual 37941A DTSC-200A - ATS Controller - Operation
© Woodward Page 15/37
Screen "LogicsManager Conditions" [all application modes]
This screen shows in list form the LogicsManager groups. From there the
operator can navigate to the according group of interest.
Navigate to the LogicsManager conditions screens
Group00: Flags condition
Group01: Alarm system
Group03: Engine control
Group04: Application
Group06: Alarms
Group08: Syst.related alarms
Group09: Discrete inputs
Group11: Clock and timer
Group12: External Dis
Group13: Discrete outputs
Group14: External DOs
Group19: ATS Status flags
Group20: ATS status flags 2
Group21: ATS alarms
Group98: LM outputs
Screen "Counters" [all application modes]
The first screen show energy counters allocated to source S1 and S2.
The second screen shows the last overlap time duration, the current phase
angle between source 1 and source 2 and the amount of load transfers since
the last reset.
Energy 0.00 kWh - Generator real energy
0.00MWh = Total generator real energy
Pos. reactive energy 0.00 Mvar - Generator reactive energy
0.00Mvarh = Total generator reactive energy
Overlap time counter 00 ms - Overlap time
00ms = Overlap time of the last transfer
Phase angle S1-S2 000.0° - Phase angle
0000.0° = Ph. angle between source 1 and source 2
Transfers to S1 - Counter transfer to source 1
00000 = Number of S1 transfers
Transfers to S2 - Counter transfer to source 2
00000 = Number of S2 transfers
Screen "Alarm list" [all application modes]
With pushing the button the operator come into the active alarm
screen All alarm messages, which have not been acknowledged and
cleared, are displayed. Each alarm is displayed in one line as alarm text,
the date and time stamp. The symbol indicates that this alarm condition
is still present.
To Next Page
Loading...
