Woodward DTSC-200A - Timer Display, Bypass, and LogicsManager

Manual 37941A DTSC-200A - ATS Controller - Operation
© Woodward Page 17/37
Timer Display
"Timer" display
If a timer is active, it is indicated in the "Messages" section of
the screen and a numerical indication in the "Timer" section
counts down the remaining time before the timer expires.
Bypass timer
If a timer is currently active, it may be bypassed with the "Bypass" button.
Note: The Bypass feature is only possible if the LED over the Bypass button is
flashing.
This means with pushing the indicated timer expires immediately and the unit
proceeds with the next operation. Refer to Appendix A: Messages on page 33
for a list of the possible timers.
LogicsManager
Some parameters of the DTSC-200A are configured via the LogicsManager (refer to Configuration Manual
37940). A typical LogicsManager screen is shown in the following. You may configure a logical operation using
various command variables, signs, and logical operators to achieve the desired logical output.
LogicsManager Screen
For configuration of the LogicsManager use the softkeys dis-
played in the navigation button overview.
Leave current screen ("Escape" / "ESC")
By pressing this softkey character you exit and go to the previous screen. If the Escape
softkey is used to leave a LogicsManager configuration screen, any unconfirmed chang-
es made will not be stored.
Change option
By pressing these softkey characters plus and minus you may change the option of the
selected LogicsManager parameter upwards or downwards.
Confirm selection
By pressing this softkey character you confirm the configured option of the selected
LogicsManager parameter.
Select parameter
By pressing this softkey character you may select the LogicsManager parameter to be
configured. Each time this softkey character is pressed, the parameter will be advanced.