Woodward DTSC-200A - Configurable Parameters; Language, Password, and Display Contrast; Horn Deactivation Settings

Manual 37941A DTSC-200A - ATS Controller - Operation
Page 30/37 © Woodward
Parameters
≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡
NOTE
Descriptions of all parameters, which may be edited/configured via the display, are described in manu-
al 37940.
Language
EN
Language
Change language {Language}
{Language} . The selection of a language will affect the following text
in the control unit:
• Text in the operating field which are not defined by an
input (i.e. discrete inputs may be a user-defined text)
• The alarm list text
• All parameters which may be changed via the unit front
panel
DE
Language
Password
EN
Password display
Password for access via the unit front panel 0000 to 9999
A password must be entered to permit configuration of the unit via the
unit panel. If a password is not entered only the displayed parameters
may be edited. All other parameters and a description of their functions
may be found in the manual 37940.
GR
Passwort Display
Display Contrast
EN
Change display contrast
Change display contrast + / -
In parameter "Change display contrast" the display contrast may be in-
creased or decreased using these softkey characters.
................. Increase the display contrast.
................. Decrease the display contrast.
................ Performs a lamp test.
GR
Displaykontrast ändern
Deactivate Horn
EN
Time until horn reset
Self acknowledgement of the horn signal 0 to 1.000 s
A horn signal is issued and the alarm LED flashes when a fault condi-
tion occurs. This signal will be disabled when the configured time ex-
pires. This is the maximum time, for which a horn signal is active (it
will also be deactivated if it is acknowledged before). If this parameter
is configured to 0, the horn will remain active until acknowledged.
GR
Zeit Hupenreset