Manual 37941A DTSC-200A - ATS Controller - Operation
© Woodward Page 31/37
Code Levels
Code level via display Info
This value displays the code level that is currently active for access via
the front panel.
Password CAN-Bus Info
This value displays the code level that is currently active for access via
the CAN bus.
Codeebene CAN Schnittstel.
Code level serial port / DPC
Code level USB Info
This value displays the code level that is currently active for access via
the USB interface.
Codebene serielle Schnittstel
Password for access via the unit front panel 0000 to 9999
A password must be entered to permit configuration of the unit via the
unit front panel. If a password is not entered only the displayed param-
eters may be edited. All other parameters and a description of their
functions may be found in the manual 37940.
Password for access via CAN 0000 to 9999
A password must be entered to permit configuration of the unit via the
CAN bus. If a password is not entered only the displayed parameters
may be edited. All other parameters and a description of their functions
may be found in the manual 37940.
Password for access via USB 0000 to 9999
A password must be entered to permit configuration of the unit via
USB interface. If a password is not entered only the displayed parame-
ters may be edited. All other parameters and a description of their func-
tions may be found in the manual 37940.
Factory setting YES/NO
The factory settings (default values) may be loaded. Select YES to en-
able the following screen to be displayed. It is possible to load the fac-
tory settings (default values) for all displayed parameters.
Set default values YES/NO
Entering YES overwrites the current configured values with the default
values. Only those parameters will be reset, which are permitted to
change in the selected code level.
To Next Page
Loading...
