EGCP-2 Communications Manual 26181
6 Woodward
Chapter 4.
Monitoring ServLink Software Operation
Now that the software has been installed on the hard drive of the computer, and
the desired hardware connections are in place between the computer and the
EGCP-2 controls, the next step is to run the software and confirm operation of
the entire communications network.
To run the EGCP-2 software, first click on the Start toolbar button in Windows
desktop, then Programs, Woodward, EGCP-2 HMI 1.00, and then click on the
ServLink server as shown here.
When you click once on the Icon, this screen will appear on the desktop. This is
the Dialog Screen, where the type of communications you are using will be
established prior to operation of the EGCP-2 monitoring software.
To Next Page
Loading...
