EGCP-2 Engine Generator Control Package Manual 26076
8 Woodward
CONFIG
...
The CONFIG KEY, when pressed, will put the right hand LCD
into the configuration mode. Configuration menu items will be displayed in the
right hand screen. Status information will continue to be displayed in the left hand
screen. Since there are various menu items and adjustments in the configuration
menu, a blinking cursor is provided in the right hand display when the configure
mode is active.
STATUS MENU KEYS:
The contents of the various status menus are described in the Status Screens
section in Chapter 3 of this manual.
SYSTEM
The SYSTEM STATUS key, when pressed displays the system
status information. The system status display is also the default status display
screen (it is always the first display shown after a power up of the control). This
display shows general information about the operation of the engine generator
set.
ENGINE
The ENGINE STATUS key , when pressed displays status
information about the engine functions and operation.
GEN
The GEN STATUS key shows three phase generator
parameters when pressed.
I/O
The I/O STATUS key provides the status of all the discrete
inputs and outputs, as well as information on analog inputs and outputs.
To Next Page
Loading...
