Woodward GCP-30 Series - Page 146

Manual 37278B GCP-30 Series - Genset Control
Page 146/174 © Woodward
No. Output Explanation
81 Left mains rotating field
82 Engine enable
Set engine enable
As long as there is a start request for
the engine and during cool down (as
long as the operation of the engine is
enabled, i.e. operation mode AU-
TOMATIC and discrete input 3/5,
emergency power, start via interface,
manual start, etc.).
Reset engine enable
If the start request is no longer
present, in the event of manual stop-
page, with a class F3 alarm, during
the engine stop time (prior to a fur-
ther attempt at starting), and if "ze-
ro" speed is detected and there is not
a start request present or coasting is
not taking place.
83 "RESET" push-button pressed
84 Preheating/firing ON (pre-assigned to relay [7]) pre-assigned default value
85 Group alarm of class F1, F2, or F3 alarm (pre-assigned to relay [8]) pre-assigned default value
Horn: after 2 min independent shu-
toff
86
#1
CHP operation power reduction level 1
87
#1
CHP operation power reduction level 2
88 Generator voltage and frequency are not available (undelayed)
89 Busbar voltage and frequency are not available (undelayed)
90
#1
--Internal--
91 Pickup has nominal speed (+/-6 %)
92 Mains voltage fault via protection device
93 Mains frequency fault via protection device
94 Phase/vector shift fault via protection device
95
#2
Load balance monitoring
96 Delayed engine monitoring time exceeded
97 Sprinkler mode is active (included Sprinkler coasting)
98
#3
IKD1 discrete input 1
99
#3
IKD1 discrete input 2
100
#3
IKD1 discrete input 3
101
#3
IKD1 discrete input 4
102
#3
IKD1 discrete input 5
103
#3
IKD1 discrete input 6
104
#3
IKD1 discrete input 7
105
#3
IKD1 discrete input 8
106
#3
IKD2 discrete input 1
107
#3
IKD2 discrete input 2
108
#3
IKD2 discrete input 3
109
#3
IKD2 discrete input 4
110
#3
IKD2 discrete input 5
111
#3
IKD2 discrete input 6
112
#3
IKD2 discrete input 7
113
#3
IKD2 discrete input 8
#1
(Option TZ01),
#2
(Option UW1),
#3
(Option SC06)