Manual 37240C GCP-30 Series - Genset Control
Settings at the Phoenix Modem
The settings refer to an example for sending an alarm message via fax.
Descriptions of the individual parameters can be taken from the operation manual of the modem.
DIP Switches
All DIP switches are set to OFF (default state).
Settings using the configuration software
Phoenix provides an application software to configure the modem for the application. Refer to the operation
manual of the device for detailed information.
The following settings form an example for sending an alarm message via fax.
Descriptions of the individual parameters can be taken from the operation manual of the modem.
To configure the modem, proceed as follows.
Configure the COM port
The phone number and the text can be set as re-
quired.
These settings configure the modem to accept an in-
coming call for remote configuration.
Page 26/38 © Woodward
To Next Page
Loading...
