Woodward LS-5 v2 Series - Page 118

Monitoring Parameter Alignment VDE-AR-N 4105
ID Parameter CL Setting range
[Default]
Description
3484 Alarm class 2 [C]
A to F, control
The alarm class speci󰈡es what action
should be taken if the parameter
alignment between the
communication devices(s) of the VDE-
AR-N 4105 system is active.
Notes
For additional information refer to ╚═▷
“9.4.1 Alarm Classes”.
3485 Self acknowledge 2 Yes The control automatically clears the
alarm if the fault condition is no
longer detected.
[No] The control device does not
automatically reset the alarm when
the fault condition is no longer
detected.
The alarm must be acknowledged and
reset by manually pressing the
appropriate buttons or by activating
the LogicsManager output "External
acknowledgment" (via a discrete input
or via an interface).
Monitoring Measurement Di󰂡erence VDE-AR-N 4105
ID Parameter CL Setting range
[Default]
Description
3490 Alarm class 2 [C]
A to F, control
The alarm class speci󰈡es what action
should be taken if the measurement
di󰈠erence (frequency,
1836 or
voltage, 1828) between the
communication devices(s) of the VDE-
AR-N 4105 system di󰈠er more than
allowed.
Notes
For additional information refer to ╚═▷
“9.4.1 Alarm Classes”.
3491 Self acknowledge 2 Yes The control automatically clears the
alarm if the fault condition is no
longer detected.
[No] The control device does not
automatically reset the alarm when
the fault condition is no longer
detected.
The alarm must be acknowledged and
reset by manually pressing the
appropriate buttons or by activating
the LogicsManager output "External
acknowledgment" (via a discrete input
or via an interface).
118 LS-5 v2 Series 37650
4 Con󰈡guration
4.3 Con󰈡gure Monitoring
Released