Woodward LS-5 v2 Series - Page 220

9. ▷
Fig. 92: Communications window
Enter the login data if required.
If the device is security enabled, the login dialog will appear.
▶
Now you are able to edit the LS-5 parameters in the main window.
Any changes are written automatically to the control unit's memory after
pressing »Enter« to con󰈡rm them..
CAN bus connection
It is also possible to connect to the unit via CAN bus, if a suitable CAN adapter is used.
We recommend to use the IXXAT USB-to-CAN converter which must use the VCI V3
driver.
⚙
To connect ToolKit via CAN:
1. ▷
Install the required drivers of the USB-to-CAN converter.
2. ▷
Connect the unit.
3. ▷
Open ToolKit and select a tool.
4. ▷
Select »Connect«.
5. ▷
Select the CAN connection in the »Connect« window.
6. ▷
Con󰈡gure the correct baud rate and timeout in the properties dialog of
the »Connect« window.
The Password for CAN Interface 1 (parameter
10402) must be entered before being able
to edit the parameters via CAN.
CAN connection troubleshooting
Description Information Corrective Action
Connection error (ToolKit freezes when
trying to establish a connection)
Active connections via infrared
ports
Temporarily deactivate the infrared port
(including virtual ports)
Active connections via bluetooth Temporarily deactivate bluetooth
(including virtual ports)
Additional CANopen devices
connected to the bus
Contact Woodward support or provide
missing .sid 󰈡le for additional CANopen
device (╚═▷ “SID 󰈡les for additional
CANopen devices”)
220 LS-5 v2 Series 37650
5 Operation
5.1 Access Via PC (ToolKit)
Released