Woodward LS-5 v2 Series - Operating Mode AUTOMATIC; Restore Language Setting

Fig. 140: LS-5x2 v2 Synchroscope in operating mode MANUAL (example)
5.3.2 Operating Mode AUTOMATIC
In the AUTOMATIC operating mode (LED at mode button»AUTO« illuminated), the circuit
breaker functions are operated via an interface, or automatically by the control unit (i.e. a
mains failure).
The function of the LS-5 depends on the con󰈡guration of the unit and how the external
signals are used.
⚙
General usage
1. ▷
Use the button »AUTO« to activate operating mode AUTOMATIC.
▶
If mode change was successful the LED at the button »AUTO« is illuminated.
5.4
Restore Language Setting
Due to the multilingual capability of the unit, it may happen that the display language of
the LS-5 is set to a language, the operator is unable to read or understand.
In this case, the following proceeding helps to restore the desired language.
The default setting is English.
⚙
Change Language Setting
ᐳ
In order to change the language setting, press the softkeys in the following order:
254 LS-5 v2 Series 37650
5 Operation
5.4 Restore Language Setting
Released