Woodward LS-5 v2 Series - Application; Application Modes Overview; LS-5 X2: Stand-Alone Application Mode

6 Application
6.1
Application Modes Overview
General notes
The LS-5 circuit breaker control units are designed to enable complex power management
applications with multiple incoming mains and bus breakers in combination with
easYgen-3400/3500 or easYgen-3400XT/3500XT equipped genset controllers.
This device combination allows to establish various applications. To make the handling for
that wide range of applications easier, di󰈠erent precon󰈡gured application modes in the
LS-5 as well in the easYgen-3400/3500 or easYgen-3400XT/3500XT are provided.
These application modes are created because some pre-con󰈡gurations are automatically
󰈡xed through the according application modes. The following chapter explains the
di󰈠erentiation of the application modes and there settings.
Not all possible con󰈡gurations can be explained in detail, but shall help to guide through
the settings according to the mode.
The control units can be used stand-alone (╚═▷ “6.2 Setup Stand-Alone Applications
(Mode A01)”) or common applications with Woodward easYgen-3400/3500 or
easYgen-3400XT/3500XT genset control units (╚═▷ “6.3 Setup easYgen & Slave LS-5x2
Applications (Mode A05)”, ╚═▷ “6.4 Setup easYgen & Independent LS-5x2 Applications
(Mode A02)” and ╚═▷ “6.5 Setup VDE-AR-N 4105 Applications”).
For detailed information on the application modes, notes on safety and examples of
special applications refer to the following chapters:
• ╚═▷ “6.2 Setup Stand-Alone Applications (Mode A01)”
• ╚═▷ “6.3 Setup easYgen & Slave LS-5x2 Applications (Mode A05)”
• ╚═▷ “6.4 Setup easYgen & Independent LS-5x2 Applications (Mode A02)”
Correlating application modes
LS-512/522 easYgen-3400/3500 or easYgen-3400XT/
3500XT
Mode Symbol Mode Symbol
LS-5 Single LS5
A01
N/A N/A
LS-5 & easYgen LS5 (up to 16 unit)
A02
GCB/LS5
A07
L-GGBMCB (max. 1 unit)
A05
GCB/L-GGBMCB
A12
6.1.1 LS-5x2: Stand-Alone Application Mode
LS-512/522 easYgen-3400/3500 or
easYgen-3400XT/
3500XT
Mode Symbol Mode Symbol Function
Single LS5
A01
None None Independent synch check relay mode CBA and CBB.
256 LS-5 v2 Series 37650
6 Application
6.1 Application Modes Overview
Released