Woodward LS-5 v2 Series - Page 36

5. ▷
Fig. 14: Attach clamp inserts
Re-install the clamp inserts by tilting the insert to a 45° angle. (╚═▷ Fig. 14/1) Insert the
nose of the insert into the slot on the side of the housing. (╚═▷ Fig. 14/2) Raise the
clamp insert so that it is parallel to the control panel.
6. ▷
Fig. 15: Tighten clamping screws
Tighten the clamping screws (╚═▷ Fig. 15/1) until the control unit is secured to the
control panel (╚═▷ Fig. 15/2). Over tightening of these screws may result in the clamp
inserts or the housing breaking. Do not exceed the recommended tightening torque of
0.1 Nm.
7. ▷
Fig. 16: Reattach terminals
Reattach the wire connection terminal strip (╚═▷ Fig. 16) and secure them with the side
screws.
36 LS-5 v2 Series 37650
3 Installation
3.2 Mount Unit (Plastic Housing)
Released