Woodward LS-5 v2 Series - Screw Kit Installation

3.2.2
Screw Kit Installation
The housing is equipped with 8 nut inserts (╚═▷ Fig. 15), which must all be tightened
properly to achieve the required degree of protection.
Fig. 17: Plastic housing - drill plan
⚙
Screw Kit Installation
ᐳ
•
Special tool: Torque screwdriver
Proceed as follows to install the unit using the screw kit:
1. ▷
Cut out the panel and drill the holes according to the dimensions in ╚═▷ Fig. 15
(dimensions shown in mm).
2. ▷
Insert the unit into the panel cutout. Verify that the unit 󰈡ts correctly in the cutout. If the
panel cutout is not big enough, enlarge it accordingly.
3. ▷
Insert the screws and tighten to 0.6 Nm (5.3 pound inches) of torque.
37LS-5 v2 Series37650
3 Installation
3.2 Mount Unit (Plastic Housing)
Released