Woodward LS-5 v2 Series - Group 24: Flags Condition

No. Name / Function Note
17.11 Free alarm 1
17.12 Free alarm 2
17.13 Free alarm 3
17.14 Free alarm 4
9.3.4.14 Group 24: Flags Condition 2
•
Flags condition 2
• Logic command variables 24.31-24.73
The command variables may be used as command variable in a logical output.
'LM' means that these logical command variables show the result of a LogicsManager
condition.
No. Name / Function Note
24.31 LM Enable SyA decoupling
24.32 LM Open CBA unload
24.33 LM Open CBA immediately
24.34 LM Enable to close CBA
24.35 LM Open CBB unload
24.36 LM Open CBB immediately
24.37 LM Enable close CBB
24.38 LM Variable system is A
24.39 LM Isolation switch open
24.40 LM Lock Monitoring
24.41 LM Flag 1 LS5
24.42 LM Flag 2 LS5
24.43 LM Flag 3 LS5
24.44 LM Flag 4 LS5
24.45 LM Flag 5 LS5
24.46 LM Open CBA in MAN
24.47 LM Close CBA in MAN
24.48 LM Open CBB in MAN
24.49 LM Close CBB in MAN
24.51 LM LED 1 (System A in range) These command variables and the
corresponding equations are available in the
display version in ToolKit and the HMI, even if
the LEDs are not available. In the display version
the variables can be used as additional internal
󰈢ags and are located there.
24.52 LM LED 2 (System B in range)
24.53 LM LED 3 (CBA is closed)
24.54 LM LED 4 (CBB is closed)
24.55 LM LED 5 (Synchronization CBA is active)
417LS-5 v2 Series37650
9 Appendix
9.3 LogicsManager Reference
Released