Woodward LS-5 v2 Series - Page 84

interface or ToolKit con󰈡guration
software.
10417 Factory default settings 0 Yes The following three parameters are
visible and restoring the con󰈡gured
parameters to factory default values
is enabled.
[No] The following three parameters are
invisible and restoring the con󰈡gured
parameters to factory default values
is not enabled.
1701 Set factory default values 0 Yes All parameters, which the enabled
access code grants privileges to, will
be restored to factory default values.
[No] All parameters will remain as currently
con󰈡gured.
Notes
This parameter is only displayed, if
Factory Settings (parameter 10417) is
set to "Yes".
10500 Start Bootloader 2 00000
[42405]
The bootloader is utilized for
uploading application software only.
The proper enable code must be
entered while the control is in access
code level CL3 or higher to perform
this function.
Notes
This parameter is only displayed, if
Factory Settings (parameter 10417) is
set to "Yes".
This function is used for uploading
application software and may only be
used by authorized Woodward service
personnel!
1706 Clear eventlog 2 Yes The event history will be cleared.
[No] The event history will not be cleared.
Notes
This parameter is only displayed, if
Factory Settings (parameter 10417) is
set to "Yes".
84 LS-5 v2 Series 37650
4 Con󰈡guration
4.1 Basic Setup
Released