Work Hero WD60LSS - Page 5

WORK HERO 60L WET & DRY VACUUM STAINLESS STEEL 2300W MAX TWIN MOTORS  WD60LSS 03
02 WORK HERO 60L WET & DRY VACUUM STAINLESS STEEL 2300W MAX TWIN MOTORS
ASSEMBLY
The cleaner should be switched o and disconnected from the mains power supply before you
start to assemble.
Part 1
1. Connect the 2-piece metal tube together.
2. Connect the handle on the hose to the tube.
3. Connect the tube to the combination oor tool or the wet pick up tool.
Tube
Handle
Tube
Combination
Floor Tool
Tube
Part 2
1. Disconnect latches on side of machine and remove the canister lid.
2. Remove all accessories from inside the tank.
3.
Replace the canister lid (with the power cord facing the opposite direction of the hose inlet)
and connect the latches.
4. Insert the hose connector into the hose inlet and turn clockwise until it locks securely
onto the machine.
5. Take the cable from the storage area and connect to the mains power supply.
6. Start the cleaner by pressing the On/O button.