17
EN
LED light indicator Status Action
Light does not turn on There is no power. Check if the power cord is connected properly to the
charger and the charger is connected to a suitable power
supply.
Green light on Boundary wire is connected
successfully; fully charged.
/
Green light on, Landroid
®
is
inside its territory but does not
move.
Boundary wire is connected in
wrong direction.
Check and reverse two ends of boundary wire.
Green light flashing Power supply is connected
successfully, while the wire is
connected unsuccessfully.
Check that the Boundary Wire has been connected
correctly to the charging base.
Check there are no breaks in the boundary wire.
Red light on Charging /
4. Turn on and Test the Installation
Adjust the cutting height to its maximum level (60mm) for the
first mow and then adjust to your preferred lawn grass height.
Place your Landroid
®
inside the working area, a few meters
from the back of the charging base. Landroid
®
, after turning
on, will go through the entire boundary wire before returning
to charging base. This allows you to check if the boundary wire
is laid out properly.
Set the main switch at the rear of Landroid
®
to Position “I”.
Press “
” button and then press “OK” button.
Your Landroid
®
now is finding its way to the charging base.
Watch the Landroid
®
as it returns to the charging base and
modify the positioning of the boundary wire if necessary.
When the Landroid
®
successfully returns to the charging
base, this means the installation has been successfully
completed!
NOTE: If the boundary wire is broken during the testing or
you find you need to extend the boundary wire, please refer
to “Joining the Boundary Wire” in Owner’s Manual for
instructions.
4.1
4.2
This is the exciting part where you can turn your Landroid
®
on for the first time.
To Next Page
Loading...
