Worx WG583E User Manual

3
l
ess Blower/Vac/Mulcher
W
G583E WG583E.9
Cordless Blower/Vac/Mulcher
WG583E WG583E.X
could cause injury.
f) Before using, always
visually inspect to see,
that the shredding means,
shredding means bolts and
other fasteners are secure,
the housing is undamaged
and that guards and
screens are in place.
Replace worn or damaged
components in sets to
preserve balance. Replace
damaged or unreadable
labels.
3) Operation
a) Before starting the
machine, make certain that
the feeding chamber is
empty.
b) Keep your face and body
away from the feed intake
opening.
c) Do not allow hands or any
other part of the body or
clothing inside the feeding
chamber, discharge chute,
or near any moving part.
d) Keep proper balance and
footing at all times. Do not
overreach. Never stand at a
higher level than the base of
the machine when feeding
material into it.
e) Always stand clear of the
discharge zone when
operating this machine.
f) When feeding material into
the machine be extremely
careful that pieces of metal,
rocks, bottles, cans or other
foreign objects are not
included.
g) If the cutting mechanism
strikes any foreign
objects or if the machine
should start making any
unusual noise or vibration,
immediately shut off the
power source and allow the
machine to stop. Remove
the battery pack from
the machine and take the
following steps before
restarting and operating the
machine:
i) inspect for damage;
ii) replace or repair any
damaged parts;
iii)check for and tighten any
loose parts.
h) Do not allow processed
material to build up in the
discharge zone; this may
prevent proper discharge
and can result in kickback of
material through the intake
opening.
i) If the machine becomes
clogged, shut-off the
power source and remove
the battery pack from the

Worx WG583E Specifications

General

Brand	Worx
Model	WG583E
Category	Blower
Language	English