10
The on/off switch is fitted with a brake function which stops your
chuck immediately when you quickly release the switch.
It is also a variable speed switch that delivers higher speed and
torque with increased trigger pressure. Speed is controlled by the
amount of switch trigger depression.
Warning: Do not operate for long periods at low speed
because excess heat will be produced internally.
SWITCH LOCK (See Fig.B)
The switch trigger can be locked in the OFF position. This helps to
reduce the possibility of accidental starting when not in use. To lock
the switch trigger, place the rotation control in the center position.
REVERSIBLE (See Fig.B)
For drilling and screw driving use forward rotation marked “ ”
(lever is moved to the left). Only use reverse rotation marked “ ”
(lever is moved to the right) to remove screws or release a jammed
drill bit.
Warning: Never change the direction of rotation when the
chuck is rotating, wait until it has stopped!
TWO-SPEED GEAR CONTROL (See Fig.C)
The drill has a two-speed gear control designed for drilling or driving
at LOW (mark is 1) or HIGH (mark is 2) speeds. A slide switch is
located on top of the drill to select either LOW or HIGH speed. When
using the drill in the LOW speed range, the speed will decrease and
the drill will have greater power and torque. When using the drill in
the HIGH speed range, the speed will increase and the drill will have
less power and torque.
2
3
4
To Next Page
Loading...
Need help?
General
