10
Lithium-Ion Cordless Drill/Driver EN
ACCESSORIES
WX176 WX176.1
Battery pack 1 1
Charger 1 1
16pc Drill bit set
(WA1115)
1 /
100pc Drill bit set
(WA1114)
/ 1
WX176.2 WX176.3 WX176.9
Battery pack 1 2 /
Charger 1 1 /
16pc Drill bit set
(WA1115)
1 1 1
100pc Drill bit set
(WA1114)
/ / /
We recommend that you purchase your accessories
from the same store that sold you the tool. Refer to
the accessory packaging for further details. Store
personnel can assist you and offer advice.
Recommended pilot-hole size for Screws
Ø
3mm 3.5mm 4mm 4.5mm
Ø
1.5mm 2mm 2.5mm 3mm
Ø
5mm 6mm 8mm
Ø
3mm 3.5mm 4mm/5mm
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE
The machine is intended for drilling (including
pilot hole) in wood, metal and plastic as well as for
driving and removing fasteners.
ASSEMBLY AND
OPERATION
ACTION FIGURE
BEFORE OPERATION
Removing the Battery Pack
See Fig. A1
Charging the Battery Pack
More details can be found in
charger’s manual
See Fig. A2
Installing the Battery Pack See Fig. A3
ASSEMBLY
Inserting the Bits See Fig. B
Removing the Bits See Fig. C
OPERATION
Rotating the Dual Chuck See Fig. D
FORWARD/REVERSE
ROTATION CONTROL
WARNING: Never change
the direction of rotation
when the chuck is rotating, wait
until it has stopped!
See Fig. E1,
E2, E3
TWO-SPEED GEAR CONTROL
WARNING: To prevent
gear damage, always
allow the chuck to come to a
complete stop before changing
gears.
See Fig. F
Drilling/driving Torque Setting See Fig. G
ON/OFF SWITCH
WARNING: Do not
operate for long periods at
low speed because excess heat
will be produced internally.
See Fig. H
To Next Page
Loading...
