The use the correct accessory for the tool and ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any anti vibration accessories are used.
And the tool is being used as intended by its design and these instructions.
This tool may cause hand-arm vibration syndrome if its use is not adequately managed.
WARNING: To be accurate, an estimation of exposure level in the actual conditions of
use should also take account of all parts of the operating cycle such as the times when
the tool is switched off and when it is running idle but not actually doing the job. This may
significantly reduce the exposure level over the total working period.
Helping to minimise your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades.
Maintain this tool in accordance with these instructions and keep well lubricated (where
appropriate).
If the tool is to be used regularly then invest in anti vibration accessories.
Avoid using tools in temperatures of 10
0
C or less.
Plan your work schedule to spread any high vibration tool use across a number of days.
ACCESSORIES
Auxiliary handle 1
Depth gauge 1
Chuck key (WX311) 1
Drill bits: HSS - 5, 6, 8mm (Each 1pc) 3
Masonry - 6, 8, 10mm (Each 1pc) 3
We recommend that you buy all your accessories from the store where you purchased the
tool. Use good quality accessories marked with a well-known brand name. Refer to ‘Working
Hints’ section in this manual or to the accessory packaging for more details. Store personnel
can also help and advise.
To Next Page
Loading...
Need help?
General
