Random orbital sander EN
7
area where power tool will move if
kickback occurs. Kickback will propel
the tool in direction opposite to the wheel’s
movement at the point of snagging.
d) Use special care when working
corners, sharp edges etc. Avoid
bouncing and snagging the accessory.
Corners, sharp edges or bouncing have a
tendency to snag the rotating accessory
and cause loss of control or kickback.
e) Do not attach a saw chain
woodcarving blade or toothed saw
blade. Such blades create frequent kickback
and loss of control.
ADDITIONAL SAFETY INSTRUCTIONS
FOR SANDING OPERATIONS
SAFETY WARNINGS SPECIFIC FOR
SANDING OPERATIONS:
Do not use excessively oversized
sanding disc paper. Follow
manufacturer’s recommendations, when
selecting sanding paper. Larger sanding
paper extending beyond the sanding pad
presents a laceration hazard and may cause
snagging, tearing of the disc or kickback.
ADDITIONAL SAFETY INSTRUCTIONS
FOR POLISHING OPERATIONS
SAFETY WARNINGS SPECIFIC FOR
POLISHING OPERATIONS:
Do not allow any loose portion of the
polishing bonnet or its attachment
strings to spin freely. Tuck away or trim
any loose attachment strings. Loose and
spinning attachment strings can entangle your
fingers or snag on the workpiece.
To reduce the risk of injury, user
must read instruction manual
Warning
Double insulation
Wear eye protection
Wear ear protection
Wear dust mask
SYMBOLS
To Next Page
Loading...
Need help?
General
