14
Reset to factory settings (Reset) (pict. 10)
The side panel of the fan casing has a slide power switch.
Turn the fan off with a slider switch, press the button
”MODE” on the control panel, hold it and turn the fan on
again with a slide power switch. When the fan is turned
on, keep holding the button [MODE] for 5 seconds until
the lamp under this button stops blinking green.
IMPORTANT! (pict. 11)
During rst connection of the fan to power mains the
rst detected indoor humidity level is saved as the basic
one. If the humidity level rises the fan goes to Silent,
Smart or Max humidity control mode.
If you want to zero the humidity threshold (e.g. while
moving the fan to another premise), turn the fan on and
off with a side slide switch.
MAINTENANCE (se page 7, pict. 1-6)
Disconnect the fan from power mains prior to any
maintenance operations!
Maintenance means periodic clearing of the fan surfaces
from dust and dirt. To clean the fan use a soft cloth
wetted in a water-soap solution.
Wipe the surfaces dry after washing.
Avoid liquid splashes on the motor and the circuit board!
8. Extra option - permanent speed (24 hours). (pict. 7)
That is an active mode for permanent operation of the fan
at low speed with no response to external signals and
humidity / motion sensor readings. To activate this
function:
Press the button [24 HOURS] and the green light
indicator conrms its turning on.
This function cancels all the previous adjustments and is
turned off by default. Press the button [24 HOURS] once
again to turn it off.
9. Extra option - airing. Automatic function. (pict. 8)
After the fan standby within 15 hours the fan switches on
for 2 hours to air the premise at 60% speed. The speed is
not adjustable. After signalling from the sensors during
AIRING mode the fan switches to any operation mode
according to the involved sensor. The light indicator
Mode blinks red when the AIRING mode is on.
10. Extra option - pull-cord switch. ( pict. 9)
After pulling the cord once in active mode the fan is
turned to 45 min. pause. After subsequent pulling the
cord the pause mode is cancelled. The light indicator
Status has green blinking light in active pause mode.
When the fan operates in standby mode the pull cord
activates the ACTIVE mode for the set time period. If
you want to switch the fan to standby mode pull the cord
once again.
Please note! If pull-cord is not required, it can easily be
removed by a scissors or a knife.
14
To Next Page
Loading...