Wow MEGA SLIDE - Connecting, Maintenance, and Storage; Connecting Multiple Slides; After-Use Procedures; Product Maintenance and Storage

6 7
GIANT
BUY 2 OR MORE SLIDES!
EZ CONNECTION SYSTEM
WOW MEGA SLIDE AFTER-USE WARNINGS & INSTRUCTIONS:
• WhendoneusingtheWOWMEGASLIDEshutthewaterhoseoff.
• Disconnectthewaterhose.
• Deflatethesidewallpontoonsbyopeningupthelargevalvescompletely.
• DeflatetheMegaSledsbyopeningupthevalvesandsqueezingthe
 airoutbypinchingthebaseofthevalve.
• Removetheanchorpinstakesfromthegroundandlet
 theslidecompletelydry.
• DonotusetheWOWMEGASLIDEwhileitsdrying.
• FolduptheWOWMEGASLIDEtofityourtamperproofstoragecontainerproperly.
• OnlystoretheWOWMEGASLIDEafteritscompletelydryinatamperproofstoragecontainer
 awayfromchildrentoavoiddangerofsuffocation.
MAINTENANCE:
• Youmaycleanyourproductusingsoapandwaterormilddetergent.
• Neverusestrongcleaningagents.
• Theproduct,whencleananddry,canbedeflatedandstoredinacool,dryareaoutofdirectsunlight.
• Todeflate,simplyunfastentheentirevalvefromthebase.Notetounfastenallvalvesifyouhave
 multiplevalvesonyourproduct.
• Avoidstoringthisproductinareasofextremetemperaturesandpleasetakeprecautionsagainstanimals
and rodents.
PRODUCT STORAGE:Topreparetheproductforstoragepleasemakesurethatitiscompletelydrytoprevent
mildewandrot.Releasealloftheairfromthechamber(s)andfoldtheproduct.Ifpossiblepleasestorethese
productsinacontrolledtemperatureanddonotexposetheproducttotemperatureslessthan40degreesF.
ColdtemperaturewilldamagethePVCmaterialandcauseittocrackatthefolds.
CONNECT MULTIPLE WOW MEGA SLIDES TOGETHER WHEN YOU BUY 2 OR MORE SLIDES
1.Ifyouareconnectingmorethanoneslidetogethermakesuretheslidesareconnectedproperlyusingthe
 pontoonsidewalllockingconnectionsystemfoundontheendofthepontoons.Afterbothslidesarelayedout
 intherecommendedareaandproperlyinflatednowyoucanlockthepontoonstogether.Please reference
the diagram below to see how to lock the pontoons together.Inserttherectangleshapemaleendintothe
 femaleendfittingandthenpushdowntolockthepontoonsinplace.
2.Thenmakesuretheendofthefirstslide’sfloorisoverlappedontopofthenextslide’sfloor.
 Theoverlapshouldalmostextendtothestartgraphiconthefrontofthesecondslide.
3.Checkallsidewallpontoonanchorstrapsandpinssotheyaresecureandthepinsare
 properlyintheground.
4.Spraybothslideswithwaterbeforeconnectingthehose.
5.Ifyouhaveasecondhoseconnectthistothesprinklersystemfittingfoundonthesecondslide.