Woxter AirBeat BT-7
manual de usuario
INTRODUCTION
Thank you for choosing to enjoy your
favorite music with the new Woxter
BT-7 irbeat headphones. This manual
allows you to get advanced for your
device, but you should be previously
familiar with the wireless function of
your mobile, tablet or BT device.
1. Do not modify, repair or disassemble
this device to avoid possible small
explosions, fires, or electric shocks.
2. Do not use any volatile or aggressive
liquid to clean your headphones.
3. Do not use your Airbeat BT-7 in
hazardous locations.
List of accessories
Headphones, USB charging cable
MAIN FUNCTIONS
1. Turn on: Press the POWER button for
4 seconds when the device is OFF (the
blue light will flash 3 times and the
device will turn on and you will hear
that it is already connected).
2. Link device: turn on your Airbeat BT-7
by pressing the POWER button and
then hold it down for 5 seconds. The
red and blue light will flash rapidly and
alternately and you will hear the link
voice.
3. Link device: use the Bluetooth
function of the mobile device or device
with which you want to link
4. Play / Pause: Press the POWER
button to play when the device is
paused and press it again if you want
to return to pause mode.
5. Volume: press quick and shortly the
VOL + button to increase the volume
and the VOL- button to lower the
volume.
6. Previous track / next track: press and
hold for one second - to go to the
previous track or the + button to go to
the next track.
7. Turn off headphones: press and hold
the POWER button for three seconds. A
beep will sound and all the lights will go
out.
8. Low battery warning: a beep will
indicate that the battery is low and the
light will flash red.
9. Charging: the headphones must be
charged via USB (red light).
10. Answer a call: press the PHONE
button once while entering the call.
11. Hang up call: press the PHONE
button once to hang the call you are
making.
12. Reject call: press and hold the
PHONE button to reject the call.
13. Redial: Press the PHONE button
twice when the device is turned on or in
playback mode.
14. Raise or lower the sound of the call:
press the - or + button repeatedly to
increase or decrease the volume as
desired.
15. No sound: while speaking, press and
hold the button -.
16. With sound: while speaking, press
the + button.
LOAD THE DEVICE
- Connect the charger to the headpho-
ne charging jack.
- During charging, the indicator light will
turn red.
- Once charged, the light will change to
blue. Unplug the charger from the
headphones.
- Use only authorized chargers to avoid
damaging your headphones in addition
to invalidating the product warranty.
- The repeated charges and dischar-
ges of the headset, over time, will cause
the battery performance to decrease.
This is normal for all rechargeable
batteries.
To Next Page
General