WIM-WG-001_E PAGE 2 of 21
Table of Contents
Page No.
1.0 INTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
1.1 WPT Power PTO
1.2 Product identification numbers
1.3 Bill of materials
2.0 SPECIFICATIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
2.1 Flywheel housings
2.2 Flywheel
2.3 Maximum RPM and maximum side load
2.4 Flywheel and flywheel housing alignment tolerances
3.0 INSPECTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
3.1 Preparation
3.2 Flywheel and flywheel housing alignment
3.3 Flywheel housing face run out
3.4 Flywheel housing bore run out
3.5 Flywheel face run out
3.6 Engine crankshaft endplay
4.0 INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
4.1 Preparation
4.2 Clutch disc alignment
4.3 Pressure plate installation
4.4 PTO alignment to engine
4.5 Hand hole cover removal
4.6 Attach PTO to engine
4.7 Engagement lever installation
4.8 Clutch adjustment
4.9 Replace hand hole cover
5.0 LUBRICATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
5.1 Main bearings
5.2 Operating shaft
5.3 Ball stud
5.4 Drawing and parts list reference
6.0 OPERATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
6.1 Engine speed
6.2 Load
6.3 Clutch engagement
6.4 Bring load up to speed
6.5 Increase engine RPM
7.0 MAINTENANCE. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
7.1 Engage clutch
7.2 Hand hole cover removal
7.3 Check clearance
7.4 Clutch adjustment
7.5 Recheck clearance
7.6 Replace hand hole cover
To Next Page
Loading...