Routine Daily Inspections
• Check machine filters.
• Check machine’s pump pressure near the pump using machine integrated pressure gauge.
• Check pressure at tool holder (main spindle end) using the WTO Pressure Device.
• Check media status – clean filter, oil percentage and coolant temperature.
• When using CoolSpeed mini Air, check the lubricating oil level.
• When using CoolSpeed mini Air, check air pressure in the supply line.
• When using CoolSpeed mini , check coolant level in the tank. Fill as required.
• Inspect CoolSpeed mini parts for cracks, fractures or distortions.
• Inspect CoolSpeed mini parts for corrosion marks, and remove if needed.
• Check machine general safety conditions.
• Inspect tool holder condition.
To Next Page
Loading...
